Re: [AG-TECH] AG 3.1 compatability

[Mike Daley <Mike.W.Daley@xxxxxxxxxxxxxxxx>]

Hi Tom
The network configuration for this test was as follows:
The node running 3.0.2 was running over a multicast enabled network.

The other two machines running 3.1 beta were both on a separate UNICAST 
only network but using AG Connector via the UMTP/GIST bridge so I guess 
it may be a fault with AG Connector. We will try some other 
configurations and see what happens.
Thanks
Mike


Thomas D. Uram wrote:
> Hi Mike:
>
> We're committed to compatibility between 3.x versions.  I haven't 
> encountered any problem like you describe that was explained by 
> software.  Are you able to isolate it to some other cause, such as 
> networking?  Can you reliably reproduce the problem in different 
> network environments?
>
> Tom
>
>
> On 8/15/07 3:53 PM, Mike.W.Daley@xxxxxxxxxxxxxxxx wrote:
> > Hi All
> > I've not been paying attention lately to the community but now have a 
> > bit of time spare.
> > Could anyone varify if there are any compatability problems between 
> > AG3.0.2 and AG 3.1 beta.
> > We were doing a few tests today between three sites, two were running 
> > AG3.1 and the other was running 3.0.2 all pointing to Argonne lobby 
> > the two 3.1 sites could see existing feeds in the Lobby plus feeds 
> > from the other 3.1 site but not the 3.0 feeds. The node running 3.0.2 
> > could only see its own feeds plus the lobby feeds not the feeds from 
> > 3.1 nodes.
> > All three machines were running Windows XP.
> > Any ideas :-)
> > Mike
> >
> > ----------------------------------------------------------------
> > This message was sent using IMP, the Internet Messaging Program.